Integrated GPS

 

The digital camera RICOH 500SE with an integrated GPS receiver is available in two versions:

• digital camera with integrated an GPS receiver (version SE-1)
• digital camera with integrated an GPS receiver and a compass (version SE-3)

 

Camera with an integrated GPS receiver (SE-1)

The RICOH 500SE is available with an integrated GPS receiver (SE-1). The GPS coordinates of your position are automatically determined when you switch on the camera.

The GPS receiver disposes of a SiRF III-chip, is WAAS/EGNOS enabled and gives you a local accuracy of 2-10m. With the WAAS or EGNOS correctional signal, the device is able to reach an accuracy of 1-5m.

Because of its architecture the camera is fit for construction sites or outdoor activity. Spray water, dust or falls from a height of up to 1m will not affect the camera.

By integrating the GPS device directly into the camera, the device covers the whole working process from position localization, over image acquisition to data transfer and placing information in the EXIF header of the picture. The complete workflow is executed by a single appliance with the push of a button.
The compact solution will also take weight off your bags. All you need is one device for all working stages hence only one recharger.

Technical specifications

Chipset	SiRF Star III, capable of WAAS/EGNOS
Channels	20 channels
Accuracy	1 - 5m, 2D RMS, WAAS enabled 5 m (2D RMS, WAAS corrected) 2,5 m (DGPS corrected)
Acquisition Time	hot start 1 sec warm start 38 sec cold start 42 sec
Antenna	internal: Active Geohelix Antenna external: Patch antenna via external antenna port
Miscellaneous	Power supply over digital camera Caplio 500SE

 

Camera with an integrated GPS receiver and digital compass (SE-3)

The GPS camera version with the digital compass (SE-3) includes an integrated GPS receiver with the previously described quality and functionality.
This version also enables you to automatically capture the direction and the horizontal tilt angle in which the picture was taken.

Technical specifications

Chipset	SiRF Star III, capable of WAAS/EGNOS
Channels	20 channels
Accuracy	1-5m, 2D RMS, WAAS enabled
Acquisition Time	hot start 1 sec warm start 38 sec cold start 42 sec
Antenna	internal: Active Geohelix Antenna external: Patch antenna via external antenna port
Miscellaneous	Power supply over digital camera Caplio 500SE

 

shop